Skip to content

April 24, 2020

Norton Commando Wiring Diagram + Lucas Rita

by Grant Tiller
Grant Tiller

A popular upgrade in the late 70s and early 80s is the Lucas RITA electronic ignition system.

Grant Tiller

Easily spotted on the Norton Commando, the Lucas RITA needed a larger points cover to house the large “reluctor” plate.

Grant Tiller

Lucas RITA units are no longer in production, but a popular source for spares and repairs here in the UK is Rex’s Speedshop

Pre-1971 (ammeter in the headlight shell and Wipac Tricon type handlebar switch) PNG 3066×1841

Grant Tiller

1971 (three wires to the master switch) PNG 3066×1841

Grant Tiller

1972 onwards (four wires to the master switch) PNG 3066×1841

Grant Tiller

1974 MK3 Early Bikes – there were around 2,000 bikes that were built around the December 1974 timeframe that have three additional fuses that can be found in the headlamp bucket.

These bikes are also wired with the old Lucas 3AW 3 wire ‘silver can’ assimilator.

1974 MK3 (Early) PNG 3066×1841

Grant Tiller

1975 MK3 this is the most common configuration, and takes us through to the final Commando that rolls off the production line.

1975 MK3 (Original) PNG 3066×1841

Grant Tiller

1975 MK3 Canadian Market – there were legal requirement in Canada around the headlamp being on while the engine was running, so the wiring diagram includes changes needed (swapping out the Warning Light Assimilator 06-6393 for the Headlamp Warning Unit 06-6392). Note that a different Master Switch is also required.

This is covered in the Factory Wiring Diagram, by notes.

1975 MK3 (Canadian Market) PNG 3066×1841

Grant Tiller

 

NOTE:

A couple of points about the way these diagrams have been drawn:

  1. where the same colour wire goes in to and out of a single connector, that connector has usually been omitted from the drawing. It’s obvious on the bike, is easy to spot and easy to troubleshoot. Leaving them off the diagrams makes them a LOT easier to read, and considerably less cluttered.
  2. wherever the earth or ground side of a component goes back to the battery, the drawing shows a red earth symbol:
    Grant Tiller
    In reality, this could be connected either to a red wire in the bike’s wiring harness (loom) OR it could be attached to the frame or engine of the bike.
    I have shown the red earth symbol each time in order to massively simplify the diagram, and make it a lot easier to understand for everyone.
    I have also coloured them red as a gentle reminder that these bikes are wired positive earth!

 

Web Analytics Made Easy - StatCounter

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

Note: HTML is allowed. Your email address will never be published.

Subscribe to comments

%d bloggers like this: